Bottom Detail B-01 PDF DWG
Bottom Detail B-02 PDF DWG
Bottom Detail B-03 PDF DWG
Corner Detail C-01 PDF DWG
Corner Detail C-02 PDF DWG
Corner Detail C-03 PDF DWG
Head Detail H-01 PDF DWG
Jamb Detail J-01 PDF DWG
Masonry Detail M-01 PDF DWG
Mid-Girt Detail G-01 PDF DWG
Mid-Girt Detail G-03 PDF DWG
Mid-Girt Detail G-04 PDF DWG
Sill Detail S-01 PDF DWG
Stack Joint Detail SJ-01 PDF DWG
Stack Joint Detail SJ-02 PDF DWG
Stud Wall Detail SW-01 PDF DWG
Top Detail T-01 PDF DWG
Top Detail T-02 PDF DWG
Top Detail T-03 PDF DWG
WP-8 Panel Detail P-01 PDF DWG
Metal flashings and trim closure are factory formed from the same material and finish as the WP-8 panel face. Self-draining bottom closures are fabricated from 20 ga. galvanized steel with 26 ga. wrapper to match the face panel.

Flashings and Closures

TEL: 815-733-5044
© 2017 Carron and Company

Insulated Metal Wall Plank

WP-8 Panel

Insulated Walls and Soffits

Field Installation

The WP-8 panel system incorporates non-mechanically fastened concealed clips which secure the panels to the structural frame. The concealed clips are fabricated from 22 ga. galvanized steel. The concealed clips secure both the exterior face and the interior face to each structural support member. As a matter of design, the WP-8 panel does not require screw fasteners. Side lap caulking is not required nor is it recommended. Installation is fast, simple and economical. Review our Installation Manual for specific procedures.
Installation Manual
Bottom Detail B-01 PDF DWG
Bottom Detail B-02 PDF DWG
Bottom Detail B-03 PDF DWG
Corner Detail C-01 PDF DWG
Corner Detail C-02 PDF DWG
Corner Detail C-03 PDF DWG
Head Detail H-01 PDF DWG
Jamb Detail J-01 PDF DWG
Masonry Detail M-01 PDF DWG
Mid-Girt Detail G-01 PDF DWG
Mid-Girt Detail G-03 PDF DWG
Mid-Girt Detail G-04 PDF DWG
Sill Detail S-01 PDF DWG
Stack Joint Detail SJ-01 PDF DWG
Stack Joint Detail SJ-02 PDF DWG
Stud Wall Detail SW-01 PDF DWG
Top Detail T-01 PDF DWG
Top Detail T-02 PDF DWG
Top Detail T-03 PDF DWG
WP-8 Panel Detail P-01 PDF DWG
Head Detail H-01 PDF DWG
Jamb Detail J-01 PDF DWG
Metal flashings and trim closure are factory formed from the same material and finish as the WP-8 panel face. Self-draining bottom closures are fabricated from 20 ga. galvanized steel with 26 ga. wrapper to match the face panel.

Flashings and Closures

TEL: 815-733-5044

Insulated Metal Wall Plank

Insulated Walls and Soffits

Field Installation

The WP-8 panel system incorporates non-mechanically fastened concealed clips which secure the panels to the structural frame. The concealed clips are fabricated from 22 ga. galvanized steel. The concealed clips secure both the exterior face and the interior face to each structural support member. As a matter of design, the WP-8 panel does not require screw fasteners. Side lap caulking is not required nor is it recommended. Installation is fast, simple and economical. Review our Installation Manual for specific procedures.
Installation Manual